Installation procedure for MAG 25x special firmware
Unpack the provided archive to the root of USB disk
Connect USB disk to STB.
Disconnect the power supply.
Turn on the power and press "menu
" button on the remote. STB menu will appear, in this menu you need to go to the next directory. Control is by arrows up/down and right/leftUpgrade Tools --> USB Bootstrap --> Ok
The firmware loads up to 10 minutes.
After successful flashing, TVIP interface will start.
Demo firmware is available through the link: "Demo version"
, this is a limited version that does not save the address of the portal after STB rebooting.